Intel 2100/2200/3200 Point to Point Setup

Please install your Intel Modem per the instructions in the included Users Guide. Once you have done this, please start your computer and insert the setup CD which was included with the modem.

Once your computer has completed booting up, it will recognize the modem and start the "Found New Hardware" Wizard. Select the option to search for drivers for the new device (it will most likely be recognized as an ATM Controller) and select the option to search for drivers on the CD-ROM.

Once the drivers have been installed, your PC may or may not reboot (depending upon your operating system). After the New Hardware Wizard has closed, the Intel Setup Wizard software should automatically start and guide you through the setup process. Please supply the following answers -

ISP Name - Getnet

ISP Tech Support Phone Number - 602-264-7000

ISP Protocol - Point to Point (PPPoA)

IP Address Settings - Server Assigned IP Address (Dynamic)

Name Server Information - Specify Address (Static) - Primary=216.19.223.25 Secondary=216.19.223.26

WINS Server - Leave Blank

In the Finished Window, click on the "Run the DSL Diagnostic Tests Now" Button, then click "Finish". The Diagnostics will test whether or not the modem software is installed correctly and the modem's ability to Train on your DSL line, and will then ask you to connect to the ISP. In the "Connect To" window, enter the username and password that you set up with Getnet, and verify the phone number to be dialed. If you have an Intel 2100, then the number should be 1,1. If you have a 2200 or 3200, then the number should be 0,32. Once you have entered this information, press connect if you have Windows 95/98/ME, or Dial if you have Windows 2000/XP. Once you have connected, verify that you can pull up a web page - you're done!